60Watt 12V Class 2 Led Downlight Drivers Transformers

60Watt 12V Class 2 Led Downlight Drivers Transformers

The 12V junction box led driver (with junction box) is 60watt 12volt 5000mA constant voltage single output class 2 led driver with 5 years warranty. The 12VDC led lighting driver accepts 120VAC 60Hz universal input voltage and use eco-friendly low profile iron materials for indoor use that to enable easy installation makes the non dimmable Led Power Supply perfect to suit for under cabinet lights, Kitchen light and other led applications. This LED Driver is high PFC 0.95 and designed to meet UL8750 safety standards and provide 8 safety protections. 

Features

． Super compact Iron case

． ETL/cETL CLASS 2 FCC RoHS

． IP20 - Indoor Use

． Auto-Reset Protection for input/output overvoltage protection, input/output overcurrent protection, over temperature

  protection, over power protection and short circuit protection

Specification

Input Voltage            120V AC 60Hz                            

Output Voltage            12V DC                   

Operating Temperature     -20℃-45℃(-4℉-101℉)  

Mode                           Constant voltage   

Dimensions (inch)         7.88"×3.35"×1.46"        

Weight                 520g        

12/24-Volt DC Installation Guide

Highly efficient, stabilized, constant voltage DC power of LED lighting

General
- This driver is to be installed in accordance with Article 450 of the National Electric Code and installed by qualified and professional electrician;
- Please make sure the driver is installed with adequate ventilation around it to allow for heat dissipation.

Before Installing
- Power must be disconnected at all times during installation.
- Observe polarity of the 12/24-volt DC output. Failure to observe polarity could damage LED lighting.
- Total wattage of all LED fixtures used must not exceed the maximum watt rating of the Power Supply.

Input Connections / Grounding
- Use the clamp connectors to secure cords and wires.
- Route and secure wires so they will not be pinched or damaged.
- All wiring must be in accordance with national and local electrical codes, low voltage Class 2 circuit. For wire runs inside of walls, use properly certified CL2 or better cabling and appropriate mounting hardware. If you are unclear as to how to install and wire this product, contact a qualified electrician. Failure to install this device properly may result in electrical shock or fire.
- Do not install Class 2 low voltage wiring in the same runs as AC main power. If AC and low voltage wires cross, keep them at 90-degree angles.
- The driver case MUST be grounded in accordance with the N.E.C. Connect the ground wire to the driver green wire.

Output Wire
- Bring the wires of the light fixture through the other clamp connector and connect them to the driver wires - positive to the red (+) wire and negative to the blue (-) wire